Pleased to hear you are working. Are you going to publish your work ? I don't think anyone has done Wiimote on a BlueGiga before. I am putting articles on the circuitsathome.com website about Wiimote and PS3 game controllers using Bluetooth and USB These may be of use to you or others. Richardby ribbotson - Offtopic
I have not used the WT11, so I am not sure how frames are sent. The 52 is the HID command for set report. If you get back 03, it is the HID response for unsupported request. So the L2CAP are connected, but the HID protocol wrong. Are you sure you are sending on the right channel. You should be sending the bytes to through the control channel ( the first one you set up, PSM = 0x11). The CID isby ribbotson - Offtopic
It sounds like you are not putting the request inside the bluetooth HID wrapper, before adding the L2CAP layer.by ribbotson - Offtopic
When you have connected AND configured both the L2CAP channels, you should recieve type 30 reports when any key is pressed.by ribbotson - Offtopic
I have an Arduino with a USB Host shield and a USB Bluetooth dongle connected. This is working to the Wiimote using HCI and L2CAP stack I wrote, this successfully sends and receives reports from the Wiimote. For connection I currently use outgoing to the Wiimote based on its bluetooth address and have to press the 1 and 2 buttons. This is fine, but I would like to understand the mode where theby ribbotson - Offtopic